Initial adjustment of servo angle

> Please turn on the switch to make Initial adjustment of servo angles.
> All servo axes are rotated to initial angles.

I executed this step, but the servo motors were just buzzing, the white gear
did not rotating. I waited few seconds to find the buzzing not stopped.

How can I confirm this adjustment is completed ?

posted by tatsuya.kubota.395 on 2014-05-24 10:44
3 comments

I suppose you are talking about step #53 on the assembly manual.
http://www.rapiro.com/assembly-manual/#53

It sounds like your battery is not sufficient. Do you use one of these batteries and you are sure that they were fully charged?
http://www.rapiro.com/power-supply/

If you are quite sure the batteries are OK and think it's initial defect. Please report that to defect@rapiro.com.

posted by ken.suzuki on 2014-05-24 17:48

Thank you for your quick reply.
I checked the spec of batteries,
and find the power isn't enough.
I've just completed assembly and
installing the related software.

posted by tatsuya.kubota.395 on 2014-05-25 00:55

Thank you for your quick reply.
I checked the spec of batteries,
and find the power isn't enough.
I've just completed assembly and
installing the related software.

posted by tatsuya.kubota.395 on 2014-05-25 00:58

Read Terms of Service upon submitting. 投稿する前に利用規約をお読みください。