My Aurdino Code will not download

When I download the standard firmware gives me a weird message.

Arduino: 1.6.7 (Mac OS X), Board: "Arduino/Genuino Uno"

Sketch uses 10,512 bytes (32%) of program storage space. Maximum is 32,256 bytes.
Global variables use 1,744 bytes (85%) of dynamic memory, leaving 304 bytes for local variables. Maximum is 2,048 bytes.
Low memory available, stability problems may occur.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.

All in red. I appreciate it in advance for the person that helps me with my problem.

posted by chebrolu.rishi on 2016-02-29 07:36

posted by chebrolu.rishi on 2016-02-29 07:37

Hello

i got the same problem. Never had this trouble when I started programming RAPIRO 4 years ago. Then I didi not try again since. But today, no way to connect to the blue eye RAPIRO. It is as if the Arduino board (set as a arduino uno as instructed in the manual) was not recognized anymore.
Someone can help? May be the programmer setting should not be AVRISP mkII?

posted by chocronolivier on 2020-01-04 01:23

Hello,

If you can not upload the RAPIRO firmware by Arduino IDE, Did you adjust the port speed 57600 bit/sec, USB Serial Port (COM3), in my case?

For another problem, You may see trouble shooting following URL, sorry you may need language translate with google:
http://www.asahi-net.or.jp/~cb9i-kn/geek/20170521rapiro2.html

posted by ichiro.kano2 on 2020-05-24 11:25

Read Terms of Service upon submitting. 投稿する前に利用規約をお読みください。