Error Message

I am getting an error message when I import the sketch to Arduino and try to upload it. Below is the error message that I get:

Arduino: 1.6.5 (Mac OS X), Board: "Arduino Uno"

Sketch uses 10,512 bytes (32%) of program storage space. Maximum is 32,256 bytes.
Global variables use 1,744 bytes (85%) of dynamic memory, leaving 304 bytes for local variables. Maximum is 2,048 bytes.
Low memory available, stability problems may occur.
avrdude: ser_open(): can't open device "COM1": No such file or directory
ioctl("TIOCMGET"): Inappropriate ioctl for device
Problem uploading to board. See for suggestions.

This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.

posted by Ghost on 2015-08-01 11:22

It's been almost a month and no response to this...not impressed at all. This was like 500 bucks....

posted by Ghost on 2015-08-25 14:12

Almost 2 months...

posted by Ghost on 2015-09-14 13:43

Hi Ghost,

I just setup my Rapiro yesterday and had to solve some problems myself. I doubt that Com1 is the right port. I have never seen a Mac with a real serial port and the connection is over a virtual com port so you have to select that for communicating with the little bugger.

In my case the port is "/dev/cu.usbserial-DA01HC31" but the IDE selected that automatically. If it didn't did you eventually forget to install the virtual com port driver?

Merry Christmas :-)

posted by christofer.dutz on 2015-12-24 20:08

( Allowed tags: <b> <s> <code> <blockquote> <img> . Automatic URL link.)

Uploaded image is placed to the bottom of the post. To add multiple images, make post once then edit the post.

Read Terms of Service upon submitting. 投稿する前に利用規約をお読みください。