Initial adjustment of servo angle

> Please turn on the switch to make Initial adjustment of servo angles.
> All servo axes are rotated to initial angles.

I executed this step, but the servo motors were just buzzing, the white gear
did not rotating. I waited few seconds to find the buzzing not stopped.

How can I confirm this adjustment is completed ?

posted by tatsuya.kubota.395 on 2014-05-24 10:44
3 comments

I suppose you are talking about step #53 on the assembly manual.
http://www.rapiro.com/assembly-manual/#53

It sounds like your battery is not sufficient. Do you use one of these batteries and you are sure that they were fully charged?
http://www.rapiro.com/power-supply/

If you are quite sure the batteries are OK and think it's initial defect. Please report that to defect@rapiro.com.

posted by ken.suzuki on 2014-05-24 17:48

Thank you for your quick reply.
I checked the spec of batteries,
and find the power isn't enough.
I've just completed assembly and
installing the related software.

posted by tatsuya.kubota.395 on 2014-05-25 00:55

Thank you for your quick reply.
I checked the spec of batteries,
and find the power isn't enough.
I've just completed assembly and
installing the related software.

posted by tatsuya.kubota.395 on 2014-05-25 00:58

( Allowed tags: <b> <s> <code> <blockquote> <img> . Automatic URL link.)

Uploaded image is placed to the bottom of the post. To add multiple images, make post once then edit the post.

Read Terms of Service upon submitting. 投稿する前に利用規約をお読みください。